|
Super Service
Award 2009
Pool Service
$95 and up
Periodic maintenance fees apply. Trees and other environmental variables additional
Repair
Estimate
$29
Waived upon
acceptance of work
5 Star Ratings
Award 2007
|
|
Studio City Pool Heater Repair Solutions from http://www.spectrumpoolcare.com. Offering licensed and professional repair and installation for homeowners in Encino, Tarzana and other San Fernando Valley cities.
Studio City Pool Heater Repair News and articles about Studio City Pool Cleaning.
Most pools are equipped with a heating unit to keep the water warm. But like any of your pool system equipment, the heater can break down. That's when it's important to have a trusted, reliable company who can come out and fix it for you. Spectrum has a trained staff of technicians who are licensed and insured with years of feild experience. Trust your repair to us, we'll seek the best solution for you.
|
|
|
Call or Click
Spectrum Pool Care
for Prompt Service
(818) 979-6444 |
|
| Studio City Pool Heater Repair Tips
There are many components in a pool or spa furnace that can prevent the burners from firing, but it is always prudent to consider some conditions in the circulation system itself that may be keeping the heater from turning on when you need it. One such failure can be low water flow. Usually this can be detected by inspecting the pool filter pressure gauge and note what the reading is. A good rule of thumb is that the filtration system should be serviced when it is 10psi (pounds per square inch) higher than the clean-reading. We recommend marking the gauge after washing down the grids and reassembling. For example, if starting at 15psi and over time climbs to 25psi, the unit is too dirty. If more dirt or algae and debris accumulate, the water will move too slow for the heater to operate. In Studio City, pool heater repair services are provided by Spectrum to quickly find the cause of the heater failure, and we find the cause that is sometimes existing outside the heater itself, as in the case of a very dirty filter or a valve turned in the wrong direction. There is a safety switch that resides in the furnace cabin that detects water pressure, and if it does not meet the requirements, the heater will shut down. Inspect the control panel for error codes as this is helpful information to relay to the servcie technician. And keep your pool system clean of debris and don't allow the filter to get too dirty. For all your repair needs, give us a call and we can be sure to solve the problem.
Read more:
|
|
|
|
